Scissor Lift Certification Edmonton

Scissor Lift Certification Edmonton - Numerous worksites and tradespeople like masons, iron workers and welders use scissor lift platforms to help them reach elevated work places. The utilization of a scissor lift is often secondary to their trade. Therefore, it is important that all platform operators be well trained and licensed. Lift manufacturers, regulators and industry work together to make certain that operators are trained in the safe use of work platforms.

Work platforms are otherwise called manlifts or AWPs. These equipment are stable and easy to utilize, even though there is always some danger because they lift individuals to heights. The following are several key safety issues common to AWPs:

To protect those working around work platforms from accidental discharge of power due to close working proximities to power lines and wires, there is a minimum safe approach distance (MSAD). Voltage can arc across the air and cause injury to employees on a work platform if MSAD is not observed.

Caution must be taken when the work platform is lowered to ensure steadiness. The boom must be retracted, if you move the load toward the turntable. This would help maintain steadiness during lowering of the platform.

The rules about tie offs do not mandate those working on a scissor lift to tie themselves off. Several organizations would however, require their employees to tie off in their employer guidelines, job-specific risk assessments or local regulations. The manufacturer-provided anchorage is the only safe anchorage wherein lanyard and harness combinations must be connected.

It is vital to observe and not exceed the maximum slope rating. The grade could be measured by laying a straight edge on the slope or by laying a board. A carpenter's level could then be placed on the straight edge and raised until the end is level. By measuring the distance to the ground and dividing the rise by the straight edge's length, then multiplying by 100, you could determine the percent slope.

In order to determine whether the unit is mechanically safe, a regular walk-around check must be done. Work site assessments are likewise essential to make sure that the work place is safe. This is vital specially on changing construction sites because of the possibility of obstacles, unimproved surfaces, and contact with power lines. A function test needs to be carried out. If the unit is used safely and properly and proper shutdown procedures are followed, the possibilities of incident are greatly lessened.

Click to Download the pdf